Member Info for Gertfrobe

Takeover it will beat going to work in a bashed up old transit van with a blocked air filter.

Davey google uncrossing trade , and good luck.

Old Rascal how about. Buy on rumour and buy on news.

Maximus10 you only ever post on SXX , I find that very strange for someone who promotes diversification such as yourself.

An article on why some investors don’t diversify and use it to their advantage.https://www.forbes.com/sites/karlkaufman/2018/07/24/heres-why-warren-buffett-and-other-great-investors-dont-diversify/

The trouble with rail is dead loads ,it’s empty most of the time .
And the skips need to travel an extra 500m per run.

20 000 000 tonnes

Thornback it’s all down to pressure variation, by removing rock you are creating a low pressure
In stable rock it’s not a problem, but you will encounter faults.

Thornback. Joe mentioned boulders . When I worked underground from time to time we encountered a Bell stone , these stones could bend a 5” ram and destroy the chock holding
The ceiling up . They became dislodged during drill and blast. And would slip slowly.
However the TBM is cutting and fitting concrete rings as it goes thereby equalising pressure.

You can pump the water out of the area, but this causes all sorts of stability issues.https://groundfreezing.com/ground-freezing-in-construction/

I feel sorry for the mouse.

K O H the night in question it was 23.45 you had 6 recommendations in about a minute.

Dillon have a look at this.https://www.theglobeandmail.com/globe-investor/investor-education/a-painful-lesson-in-when-stop-loss-orders-dont-work/article625413/

If you don’t ask you don’t get.https://www.ebay.co.uk/itm/POLYHALITE-from-Germany-RARE-MINERAL-2-0-cm-/283108286016

40 year old Transit vans . In this fictional drift.

Polyminer pit bottom to the face is 5 miles . You stated you were building a drift to overcome this
You need to get miners to the face . How are you going to do this.

Polyminer, I have done a calculation of your fictional drift . The maximum decent , assent of a man rider conveyor is 1 in 20 . The seam is a mile deep so 1 in 20 , that’s 20 miles . Maximum speed for a man rider is 5mph , that’s 4 hours to the face ,and 4 hours to the surface . When are they going to do any work .

I don’t believe you are a miner . Your comments about a drift mine going down a mile deep , where would you enter the drift Blackpool ,and you know absolutely nothing about conveyors.
1 tonne load per meter. There’s more sense in a tin of corned beef.

They haven’t got people like you working for them.

Are you building a drift into the sea.
1 tonne per meter . 7 meters per second , that’s 55400 tonnes in 2 hours.